Assembly; Start-Up; Working With The Push Sweeper; Maintenance And Care - ATIKA HKM 680 Notice Originale

Please note the attached assembly instruction
sheet!
Remove the debris container (9) from the device
►
and remove the accessories bag (16).
Turn the device upside down and fasten both circular
►
brushes (10) to the circular brush fixtures (12) with the
ST3.9 x 16 screws supplied (11).
► Now turn the device right side up again so it will rest
on the wheels and insert the debris container (9) again.
Move the lower handle hoop (1) up and fix it with the
►
handle locks (6+7).
Place the upper handle hoop (2) on the lower handle
►
hoop (1) and fix it each with a mushroom head screw (3) per
side. The appropriate choice of holes in the upper handle
hoop (2) provides you with two possibilities of height ad-
justment.
► Place the spacers (4) on the mushroom head screws
(3) so that the rounded sides rest against the upper handle
hoop (2). Now fasten the connection on both sides with one
knurled nut (5) each.
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
 Check that the machine is completely and correctly assem-
bled.
 Before each use, check
there are no damages at the machine

whether the debris container, handle hoop and brushes

are firmly mounted

Working with the push sweeper

Firmly hold the device with both hands when working.

Always work on dry, nonskid and flat ground.

Avoid abnormal posture. Provide a safe standing position

and keep at any time the balance.
Push the device over the area to be swept, at normal

walking speed (approx. 4 km/h), ahead of you.

Sweeping only takes place when the device is pushed
forward.
Dirt on edges or in corners is caught and cleaned by

the circular brushes (10).
Empty the debris container (9) regularly after each

sweeping or when it is full.

Assembly

Start-up

Maintenance and Care

Before each maintenance and cleaning work:
- wait for standstill of the beater
Maintenance and repair work other than those described in this
chapter is only allowed to be carried out by service staff.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Maintenance
To guarantee a long and reliable usage of the product carry out
the following maintenance works regularly.
Check the machine for obvious defects such as
 loose fixtures
 worn or damaged components
 correct assembly and faultless covers and protective devic-
es
Necessary repair work or maintenance has to be carried
out before using the power tool.

Observe the following to maintain the operability of the
machine:
 Clean all moving parts regularly.
 Remove dust and dirt using a soft brush, a dry or wet cloth.
 Do not clean the machine with running water or high-
pressure cleaners.
 Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.
 Keep handles dry and free of oils and grease.
Water, solvents and polishing agents shall not be
applied.

Storage

Store unused products in a dry, locked place out of the reach

of children.
Empty the debris container (9) each time before it is

stored.
Fold the handle hoops (1+2) forward to save storage

space, and place the device vertically against a wall.
Before a longer period of storage carry out the following to

'
extend the machine s service life and ensure an easy operat-
ing:
 thoroughly clean the device
Care
9