Unpacking The Generator; Overview Of The Generator - Parker UHPN2-550 Mode D'emploi

2.6.2 Unpacking the Generator

Once ready to install, remove the equipment from the packaging and check for signs of damage. Verify that the items listed in the table below
have been shipped with the generator.
Description
1/8" BSPP - 1/8" Tube Fitting
1/4" BSPP - 1/4" Tube Fitting
1/8" BSPP Exhaust Silencer
Dowty Seal
UK electrical supply cable
European electrical supply cable
USA electrical supply cable
(1) The UK and European cables are supplied with the 230 Vac rated generators, the USA cable is supplied with the 115 Vac rated generators.
If any items are missing or damaged please contact your local Parker office. Do not attempt to power up the generator.

2.6.3 Overview of the Generator

1 Pressure Relief Valve (Compressor version only)
2 Column Inlet pressure gauge
3 Receiver pressure gauge
N Outlet pressure gauge
4
2
N Outlet pressure regulator
5
2
N Mass Flow Controller bypass valve.
6
2
Items 1 and 5 are preset at the factory and must not be adjusted by the user.
Note. The pressure gauges are supplied for diagnostic and indication purposes only.
6
UHPN2 UHPN2
550 550C
1 1
1 --
1 1
2 1
(1)
1 1
1 1
1 1
7
8
9
10
11
12
UHPN2 UHPN2 UHPN2
750 750C 1500
1 1 1
1 -- 1
1 1 1
2 1 2
1 1 1
1 1 1
1 1 1
Control Panel
Fused IEC320 Inlet Socket and power switch
Remote switching and MODBUS interface
MFC N Outlet Port
2
N Outlet Port
2
Compressed Air Inlet Port (Non compressor version only)
UHPN2 UHPN2 UHPN2
1500C 3000 3000C
1 1 1
-- 1 --
1 1 1
1 2 1
1 1 1
1 1 1
1 1 1