Bimar S600.CH Notice D'instructions page 12

model by a qualified professional, who should ensure that the size of the cable is suitable for the
power used by the unit. The use of adaptors or extensions is generally not advisable; if it is
necessary to use them, they must comply with safety regulations and the total current (amps) must
 The plug point must be easily accessible so as to easily remove the plug in case of an emergency.
not be rated lower than the maximum current of the the appliance.
 Place the convection heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or flammable material (spray cans) and from materials that
can be deformed by heat. Make sure there is 100cm of free space in front of the heater and 30cm
 The surface must be stable, not sloping (as the unit may fall over), heat resistant.
free space on both sides and at the back (at the portable installation).
 Ensure that the power cable is correctly positioned and does not come into contact with hot parts
or sharp edges, nor become wound around the appliance itself, is not twisted and does not snag,
in order to prevent the appliance from falling. Make sure there's no risk of tripping, to prevent
 Make sure that the air inlet and outlet are not blocked, to prevent fire hazards or possible
people from accidentally tripping over it or being injured.
 If there is a fault or the appliance is not working correctly, switch it off and have it checked by a
overheating; do not cover the device, nor use it for drying laundry.
qualified professional. Repairs done by an unqualified person can be dangerous and cause the
guarantee to become void.
Portable installation
Warning: the appliance must run only if its feet are correctly assembled.
To use the appliance, equally assemble the two feet supplied as follows:
- Always unplug the appliance before you assemble.
- Put the appliance down horizontally on a flat, smooth
surface.
- Position the feet correctly (see figure), on the convector,
secure their blocking using the screws supplied.
Wall installation
1) Warning: the feet not must be assembled.
2) With wall installation, the wall to which the appliance is secured must be made of masonry and/or
of heat-resistant material (not wood, or synthetic material which can easily overheat); also, follow
these indications for the installation:
3) The appliance must be positioned so that the bottom side is away from the floor at least 40cm.
4) The upper grill is perfectly horizontal (see fig.1).
5) At a distance of at least 30cm from the corners of walls.
6) At a distance of at least 60cm from the corners of walls.
7) At a distance of at least 100cm from flammable materials (curtains, fabrics, etc.).
8) Not beneath socket outlets
The heater must be installed fit using the 3 "lock hole slots" in the rear panel:
-
fix two holes to the wall at a distance of 36 cm apart, the three hole for the locking flange must
be made 25,2cm below the previous 2 (first drill the holes is good to measure the distance of
the above holes), make the holes on the wall, inserting the hooks into the slots provided with
screws
- Hang the convector heater on the wall by inserting the hooks into the slots provided in the rear
panel, slightly moving the appliance to the left and then down to secure it properly.
- At the end, ensure that the fan heater is firmly secured.
Fig.1 Fig.2
12/37