Bimar S600.CH Notice D'instructions page 11

 Do not leave the appliance exposed to atmospheric conditions (sun, rain,
 Should the appliance fall or not work correctly, disconnect the electric cable
etc..).
immediately. Check that it is not damaged, and thereafter turn it back on: if in
 Do not pull on the power cable or the appliance itself to unplug the appliance
any doubt, consult a qualified professional.
 Do not pull on the power cable to move the appliance.
from the mains.
 Do no use the appliance if it does not work properly or if it appears damaged;
 Use the convection heater only when in a vertical position.
when in doubt, contact a qualified technician.
 Avoid allowing the appliance to overheat; to this end, check that the inlet and
outlet are free from obstructions: do not leave anything hanging over or under
the unit. Should overheating occur, the in-built safety device will stop the
convection heater from running. To restore operation, remove the plug from
the mains and wait for it to cool (about 20-30 minutes) and insert the plug into
 The heater must not be located immediately below a socket-outlet.
the plug point once again.
 Do not use this heater with programmers, timers or with any other device
that automatically turns on the appliance, as this could pose a fire risk
 If the supply cord is damaged, it must be replaced by the manufacturer, its
should the device be covered or positioned incorrectly.
 Do not use this heater in the immediate surroundings of a bath, a shower or a
service agent or similarly qualified in order to avoid a hazard.
swimming pool.
 After unpacking, check the integrity of the appliance; if in doubt, do not use it and contact a
INSTALLATION
qualified technician. The packaging materials (plastic bags, polystyrene, metal staples, etc.) must
not be left within reach of children, as they constitute possible safety risks and must be disposed of
according to applicable regulations. Warning: any stickers or advertising material applied to the
 Before connecting the heater check that the voltage shown on the specifications plate corresponds
inlet grid or air outlet or on the base of the unit must be removed before using the appliance.
to that of the electrical supply, and that the plug is effectively grounded. In the event of
incompatibility between the power supply and the plug, have the plug replaced with a suitable
11/37