Sunex Tools 7793B Manuel D'opération page 4

CHECKING THE HYDRAULIC FLUID LEVEL
This is the safety alert symbol used for the CHECKING THE HYDRAULIC FLUID LEVEL section of this manual to alert you to
potential personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Turn the #1 release valve knob counterclockwise to lower the telescopic rams all the way down.
2. Use a 14mm wrench to remove the #3 vented fill plug.
3. The fluid level should be 2 3/4" below the #3 vented fill plug hole and no more than 4 3/8" lower. If the fluid level is higher than 2 3/4"
from the fill plug hole, remove fluid to arrive at the proper level. If the fluid level is lower than 4 3/8" from the fill plug hole, add fluid to
arrive at the proper level.
OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Lift the vehicle to the desired work height and support the vehicle in accordance with the lift manufacturer's recommended
support procedure and all the instructions and warnings in this manual.
2. Use an under hoist stand rated greater than the weight of the engine to support the engine before unbolting the transmission from the
engine or bolting the transmission to the engine.
3. Position the transmission jack directly under the transmission. Depress the large foot pedal up and down in order to raise the
saddle to a height very close to the center of balance point of the transmission oil pan but do not touch the transmission.
4. Adjust the #S02 fingers on the saddle so that the bent up section of the fingers will fit in the mounting flange around the perimeter of
the transmission oil pan. Once the fingers are properly positioned tighten the wing nuts that secure the fingers to the saddle. Slowly
and gently pump the jack so the connection is made and then secure the transmission to the jack's saddle with the safety chain
provided. Sometimes it is necessary to turn the fore and aft and side to side tilt knobs so the saddle is in the proper alignment with
the transmission pan before securing the load to the saddle.
5. Make sure the safety chain is very tight when securing the transmission to the saddle and before raising or lowering the transmission.
6. Remove the transmission from the engine according to instructions in the vehicle service manual.
7. Once the transmission has been disconnected from the engine, very slowly depress the release pedal to make sure the jack's saddle
and transmission do not hang up on any undercar components, wiring, fuel lines, etc. Continue to lower the jack all the way down.
8. When installing a transmission, follow the above instructions but in the applicable order and according to the vehicle
manufacturer's installation procedure.
7793B Rev. E
Figure 1
1
3
4
Figure 2
H
Between 2 / ˝ and 4 / ˝
3 3
4 8
rev. 1/17/17