Operating Instructions; Operating Control Panel - Napoleon Cinema Insert Serie Manuel D'installation Et D'utilisation

WARNING
!
• Ensure the house circuit breakers for the power supply are turned on. When initially connecting the appliance
into a power source, the appliance will perform an LED check. The appliance will fl ash on and off for 5 seconds.
Once the appliance has been plugged into a grounded electrical outlet or hard-wired to a dedicated 120V power
supply, it is ready to operate.
4.1

operating control panel

The Control Panel is located on the top front of the appliance.
Power
Flame & Ember
Light Control
Heater
Control
Timer
Decorative Light
(NEFB27H &
NEFB29H only)
F° / C°
Switch
Heater
Lock
Temperature
Control

4.0 operating instructions

Turns the appliance on / off.
Controls fl ame brightness and ember light.
5 Settings: Flame & ember off (F0), ember on but fl ame off
(LL), small fl ame & ember (F1), medium fl ame & ember (F2),
brightest fl ame & ember (F3).
Turns the heater and blower on / off.
4 Settings: Heater & blower off (HO), blower on (BL), low
heat (H1), high heat (H2).
Timer can be programmed to run appliance for specifi c
lengths of time (30mins. minimum to 6hrs. maximum).
Controls decorative light settings.
4 Settings: Decorative light off (do), white colour (d1),
auto-cycle from white / orange / blue / orange-blue / white-
orange / white-blue (d2), lock to desired colour (d3).
NOTE: It will take 8.5 seconds to switch between on d2
setting.
Control temperature format (Fahrenheit or Celsius).
Press and hold the fl ame button for 5 seconds.
Heater button can be locked or unlocked by holding the
heater button for 5 seconds.
Press and hold the timer button for 5 seconds. This will
change the buttom to Temperature Control, or vice versa.
7 Settings: 16°C (61°F), 18°C (64°F), 21°C (70°F), 24°C
(75°F), 27°C (81°F), 29°C (85°F) and OFF.
EN
13
W415-1454 / G / 04.01.19