Krups ESPRESSERIA AUTOMATIC EA 80 Série Utilisation Et Entretien page 73

Problem
The coffee does not
come out of the cof-
fee tube (20).
The coffee grinder
makes a strange
noise.
The grinder setting
button (13) is diffi-
cult to turn.
No steam comes
out of the steam
nozzle (21).
There is not enough
frothed milk.
The frothed milk is
not thick enough.
The auto-cappuc-
cino accessory (op-
tional) does not
suck up the milk.
After filling the water
tank (10), the war-
ning message re-
mains displayed on
the screen.
The cleaning or des-
caling programme
will not start.
Probable causes
The tube is blocked.
Foreign particles are inside the grin-
der.
Has the grinder setting button been
moved when grinding was not taking
place ?
The nozzle or the nozzle support is
blocked.
Check that steam is coming out of
the nozzle.
Check if the small air inlet in the
upper part of the nozzle is blocked.
The recipient and milk are not cold
enough.
The milk is not fresh enough.
Check if the two ends of the small
stainless steel tube are connected to
the steam nozzle.
Check that the accessories are
connected correctly to one another
and that they are not blocked.
The water tank is not fitted correctly.
The float at the bottom of the tank
does not move freely.
The water tank is scaled.
Programme error.
Use and maintenance / SERIE EA 80xx
KRUPS Espresseria Automatic
Corrective actions
 Unblock the tube with the clea-
ning wire or a toothpick.
 Contact KRUPS Customer
Service.
 Only turn the setting button
during grinding.
 Remove the steam nozzle
from its support and unblock
these two parts using the clea-
ning wire.
 Temporarily remove the Claris
cartridge.
 Unblock the steam nozzle with
the cleaning wire.
 Unblock the inlet, dry it and if
necessary rinse it with water.
 Make sure the recipient and
milk are cold before frothing.
 We recommend using very
fresh pasteurised or UHT milk.
 Correct the position of the
stainless steel tube.
 Connect the accessories cor-
rectly to one another and un-
block them if needed.
 Fit the water tank correctly.
 Rinse the water tank under
water and descale if required.
 Unplug the appliance then
plug it back in and switch it on.
Restart the programme.
33