Portability Kit Installation - Coleman Powermate PM0525751 Mode D'emploi

TOOLS REQUIRED: 1/2" and 5/8" sockets and ratchets, hammer, block(s) of wood (minimum of 6" tall).
Refer to the parts list on page 9.
WHEEL INSTALLATION
1. Block up end of generator opposite the fuel tank cap to install wheel kit.
2. Slide the axle (item 53) through the wheel brackets on the carrier, then through a wheel (item 52), with the offset side of the
wheel hub against the wheel bracket.
3.
Secure the wheel to the axle with the axle cap (item 51), tapping the cap onto the axle with a hammer.
4. Repeat above instructions for the remaining wheel.
FOOT INSTALLATION
1. Blocking up the stator side of the generator, place spacers (item 49) and a foot (item 48) under the carrier channel. Thread
a 5/16-18 x 3.00" bolt (item 50) through the mounting holes and thread a 5/16 nut (item 22) to the bolt to secure the foot to the
carrier. Caution: Do not over tighten so that the foot material collapses.
2. Repeat step 1 for the remaining foot.
HANDLE INSTALLATION
1. Place handle (item 54) over carrier tubing on same end as feet, centering handle on the carrier.
2. Slide 7/16 x 2" bolt (item 55) through handle as shown in diagram and secure with 7/16" nyloc nut (item 56). Tighten until
handle is securely clamped to the carrier tubing.
3. Apply aerosol hairspray or similar adhesive to the handle (item 54), and then slide the handle grip (item 57) onto the
handle. The aerosol hairspray will allow for easier assembly and will adhere the grip to the handle.
NOTE: When using a generator cover with this portability kit, the handle must be moved to the downward position.
English

PORTABILITY KIT INSTALLATION

3