Publicité
STEP 7 - ATTACHING GLASS DRAWER FRONT
1. Install 2 #8-32 x 1/2" screws (203-1219) WITHOUT washers on the bottom of each bracket in the drawer front. Do not tread all the
way through so that the screws can be hung on the keyholes in the next step, See Figure 1.
2. Hang the drawer front on the two keyholes on each side of the drawer box. See Figure 2.
3. Install the remaining screws WITH washers into the two remaining threads in the drawer front bracket as shown in Figure 3. Tighten
all screws after the drawer front is level and even with the side kits.
4. Snap the screw covers over the screws by squeezing gently at "Robern".
1
2
3
4
Part no. 209-1274-rA rev. 06/16/17
Curated Cartesian H2
© 2017 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
11
Installation instructions
Publicité
Chapitres
