Reinstalling Oven Doors With Bottom Hinge; Aligning Side Hinge Oven Doors - Thermador Professional Serie Guide D'installation

Reinstalling Oven Doors with Bottom
Hinge
To replace the oven door:
Holding the door firmly in both hands, grip it on either
1.
side. Do not grip by the handle.
Tilt the door back slightly towards you until it opens
2.
about 7" at the top.
Slide the hinges into the slots as far as they will go and
3.
then lower the door straight down. The angle of the
door may need to be adjusted slightly to allow the
hinges to engage properly and the door to lower into
place. The door should lower about 3/4" and stop. If
not, the hinges have not engaged properly and the
door could fall if it is released.
Lower the door into the fully open 90° position. If the
4.
door will not lower all the way to the 90° position, the
hinges are not correctly seated. The door should be
straight, not crooked.
Push the levers on both the hinges up and forward
5.
until they are locked into the slot, flush with the front of
the oven body.
Close the door gently. It should close all the way.
6.
Gently open and close the door several times to be
sure it is correctly installed and securely in place.

Aligning Side Hinge Oven Doors

Note: Only align the side hinge oven doors after the unit
is fully installed into the cabinet.
Tip: The gap between the top of the closed oven door
and the control panel (or upper door for lower cavities in
double ovens) should be uniform from side to side.
To align side hinge door:
Check to see if the side hinge oven doors are properly
1.
aligned.
The door should pull itself closed smoothly when the
striker engages the roller as the door is closed.
Fig. A-Door is too low if hinge side is above level. A
2.
bump will be felt when the striker comes in to contact
with the realignment roller.
Fig. B-Door is too high if latch side is above level.
3.
Interference will be felt between the striker and the
catch receiver. Door needs to move down on latch
side.
13