Specifications; Preparing For Installation - Husky HDC302000 Guide D'utilisation Et D'entretien

Pre-Installation

SPECIFICATIONS

Horsepower (HP)
Pump Type
Voltage
Air Delivery @ 175 psi
Air Delivery @ 90 psi
Air Delivery @ 40 psi
Max . Air Pressure
Pump-up Time (0-175 psi)
Recovery Time (145-175 psi)

PREPARING FOR INSTALLATION

□ Remove box.
□ Unbolt the air compressor unit (A) from the shipping skid.
Using a ratchet with a 1/2 in. socket.
□ Remove the bolts holding the rear leg in place.
□ Remove the bolt holding the shipping plate (1) in place
at the front of the air compressor unit (A).
□ Remove the air compressor unit (A) from the skid. This may
require at least two people - one person to carefully roll the
unit off the skid and one to help maintain balance so the unit
does not topple.
□ While firmly holding both handles slowly tilt compressor
toward you. Once the compressor is fully off the skid, carefully
place the unit on the ground taking caution
to not scrape or mark the floor.
18"
18"
1.8
2-Stage Oil Lubricated
120 Volts, 15 Amps
60 Hz, 1 Phase
3.9 SCFM
4.1 SCFM
4.4 SCFM
175 PSI
9 Minutes, 30 Seconds
About 75 Seconds
18"
A
18"
Tank Outlet Size
Oil Capacity
Depth
Width
Height
Shipping Weight
WARNING: Disconnect, tag, and lock out power source,
and then release all pressure from the system before
attempting to install, service, relocate, or perform any
maintenance.
WARNING: This compressor is extremely top heavy. Enlist
additional help to remove it from the shipping skid.
CAUTION: Never use the shipping skid for mounting the
compressor.
IMPORTANT: Provide a minimum clearance of 18 in.
between the compressor flywheel or fan and the wall,
and ensure clear access to the drain valve to facilitate
condensate drainage.
IMPORTANT: It is extremely important to install the
compressor in a clean, well ventilated area where the
surrounding air temperature will not be more than 100 °F.
IMPORTANT: Do not locate the compressor air inlet near
steam, paint spray, sandblast areas, or any other source of
contamination.
IMPORTANT: This compressor is not intended for outdoor
installation.
A
9
Please contact 1-888-43-HUSKY for further assistance.
1/4 in. NPT
Approximately 24 ounces
18.5 in.
26 in.
48.5 in.
202 lbs
HUSKYTOOLS.COM