Pre-Installation
PLANNING INSTALLATION
It is extremely important to use the compressor in a clean,
well ventilated area where the surrounding air temperature
will not be more than 100°F. Provide a minimum clearance
of 18 in. between the compressor flywheel or fan and the
wall, and ensure clear access to the drain valve to facilitate
condensate drainage. Do not locate the compressor air inlet
near steam, paint spray, sandblast areas, or any other source
of contamination.
TOOLS REQUIRED
Ratchet and
1/2 in. Socket
9/16 in. Socket
HARDWARE INCLUDED
Part
Description
AA
Isolater Foot bolt
BB
Locknut - 5/16 - 18 Spinlock Nut Bolt
CC
Coupler - 1/4 in. I/M Steel Coupler
NOTE: Hardware not shown to actual size.
Safety Goggles
AA
IMPORTANT: This compressor is not intended for
outdoor installation.
Work Gloves
BB
6
Adjustable
Wrench
CC
Quantity
2
2
1