Software Update; Troubleshooting; Disposal - Samsung DTB-B460F Consignes D'utilisation

OPERATING THE RECEIVER

4.5 Software Update

Using this function, you can check if a new version of the
software is available and upgrade the software if available.
● To upgrade the software, select 'OK' and press the OK
key.
● Selecting this will take about 2 minutes to check if a new
version of the software is available. If a new version is
available, the software upgrade starts.
● If there is no new version, the "You don't need to
upgrade software!" message appears.
● To cancel the upgrade, select 'Cancel' and press the
OK key.
GB-26
D i g i t a l T e r r e s t
TROUBLESHOOTINGS
In some region, the digital terrestrial signal may be weak.
So you'd better use the antenna in which the booster was built, for watching the
weak signal channels.
You can download and upgrade the system software of the receiver through
a specific channel designated by the broadcaster.
The Distributor will provide you with more information about that.
Problem Possible cause
No display LED on Power cord
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode;
Scart not connected tightly
to video output of television;
incorrect channel or video
output selected on television
No sound Audio cord connected
incorrectly;
Loudness level = 0;
Muting active
Remote Control does not Incorrect operation;
operate directly
Batteries dead or inserted
incorrectly
Poor picture quality Signal strength too low
On-Screen Error Message Antenna cable not connected
"Searching for signal" or not tight;
incorrect position of the
antenna;
On-Screen Error Message Receiver not yet set
"Channel data does not
exist."

DISPOSAL

The device, packaging material (e.g. Styrofoam) and the batteries must never be
disposed of with household refuse. Please obtain appropriate information about the
regulations in your community, and dispose of all refuse in accordance with regulations
at the separate locations provided.
r i a l R e c e i v e r
Solution of the problem
Power cord plug in correctly
Set receiver to "On";
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Check connection and correct;
Increase loudness on television set;
Press the MUTE key
Point remote control
towards the Receiver.
Replace batteries or insert correctly
Check the signal strength in
the "Manual Scan" menu, correct
alignment of your antenna
Check connection and correct;
Check position and correct,
Check the signal strength in
the "Manual Scan" menu
Scanning of in "Installation" menu
GB-27