Guarantee And Support - Philips 1000 Série Mode D'emploi

Problem
The appliance does
not shave long hairs.
The appliance does
not work as well as
it should.
The appliance pulls
at the hairs.
The appliance works,
but the result is
uneven.
The appliance does
not work.

Guarantee and support

If you need information or support, please visit the Philips website at
www.philips.com/support or read the worldwide guarantee leaflet.
Guarantee restrictions
Cutting units are not covered by the terms of the international guarantee
because they are subject to wear.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in your
country.
Cause
The hairs are too long.
Hairs may be stuck in
the precision trimming
head or precision
shaving head.
You move the appliance
too fast.
The disposable battery
is empty.
You press the appliance
onto the skin too hard.
The trimming comb is
not in full contact with
the skin.
The disposable battery
is empty or has been
inserted incorrectly.
Solution
Pre-trim long hairs with the precision trimming head
and move the appliance against the direction of hair
growth. Make sure that the appliance is fully in contact
with the skin.
Clean the precision trimming head or the precision
shaving head (see chapter 'Cleaning').
Do not move the appliance too fast.
Insert a new battery.
Do not press the appliance onto the skin too hard,
as this may cause the hair length after trimming to be
shorter than the indicated hair lengths.
When you use one of the combs, always make sure it
is fully in contact with the skin.
Always move the appliance against the direction
of hair growth. As not all hairs grow in the same
direction, this means that you have to move the
appliance up, down and sideways.
Replace the battery or insert it correctly.
ENGLISH
11