Mounting Bracket - Danfoss EvoFlat WSS Guide D'installation

Mounting and installation instructions EvoFlat
5.9 Return temperature limiter FJVR (10-55°C)
The return limiter type FJVR automatically controls the return tem-
perature from heating system.
The return temperature limiter should be set to the required max-
imum return temperature, in compliance with the local demands.
Factory setting: 3.
5.10 Fitting piece
The flatstation is equipped with a fitting piece for energy meter.
Mounting of energy meters:
1: Close ball valves
Close the ball valves on DH Supply and DH Return, if there is water
on the system.
2: Loosen nuts
Loosen the nuts on the fitting piece.
3: Remove fitting piece
Remove the fitting piece and replace it with the energy meter. Do
not forget the gaskets.
4: Tighten connections
After mounting of the energy meter remember to check and tight-
en all threaded connections.

5.11 Mounting bracket

Monting bracket for the heat meter display
The heat meter display can be fixed on the mounting bracket
which normally must be ordered separately. Check your heat me-
ter supplier for more informations.
AQ15928645880503-020501 © Danfoss | Produced by Danfoss Redan A/S | 2020.12 | 19