INNO TR131 Instructions D'installation page 2

TR131 Installation Procedure for the individual Vehicle Model
Manufacturer Vehicle model Vehicle type
BMW 3 Series
Vehicle preparations
Outside of vehicle →
Roof
Cover
3
Fig-1
Carrier installation locations
Protection sheet
Nut of the vehicle
Fig-2
End of radius curve
Protection sheet
Protection sheet
Roof molding
Loading conditions
Model year
Maximum
Load Capacity
140
lbs
( kg)
64
Sedan 2012 -
( Load + Base rack
+ Attachments )
Cleaning the installation area on the
vehicle
Wipe dirt and oil off the roof and
moldings using diluted mild detergent,
and then dry the wiped area.
*Shaded area in the figure.
●Do not use organic solvents such as thinner or benzene to
clean dirt and oil.
Lifting the cover of the carrier
installation locations
Applying the protection sheets
Apply the protection sheets to the area of
roof molding on the roof. Apply each
protection sheet aligning its center to the
nut on the vehicle as shown in the figure
(see Figure-1), and also place one edge
of the protection sheet along with the end
of radius curve on the roof molding
(see Figure-2).
3132601TR1312B
EN-2
EN
Bike
Spacer
Cushion base
3
Spacer
Spacer
Torque：
４N・ｍ
35mm
Bolts (long)
Enlarged
［M6×35］
View
-A
-EN
Placing the cushion bases
Insert the spacer into the cushion base
installation hole. Align the hole with the
nut of the vehicle, and place it over the
cover on the installation location.
Cushion base
Cover
Cushion base
Cover
Attaching the base brackets
Place the base bracket on the
cushion base. Hold them so the
cushion base is parallel to the roof
molding. Fixate them with the long
Hex Wrench
Bolts (long) bolt [M6x35] until the bolt is firmly
[M6x35]
tightened.
Base bracket
Base bracket
●All base brackets (4 pcs.) are identical. The bracket is
symmetrical with respect to the side-to-side axis; its
installation orientation does not matter.
Cushion base
Body
EN-3
3132601TR1313B -EN -A