Kärcher GP 40 Mode D'emploi page 20

Danger
To avoid risks, all repairs and replacement of spare parts may only be carried out by au-
thorized customer service personnel.
First pull out the plug from the mains before carrying out any tasks on the machine.
Fault
Pump runs but does not
transport
Pump does not run or
suddenly comes to a
standstill during opera-
tions
Pump transports is re-
ducing or transported
quantity is too low
Our Kärcher branch will be pleased to help you further in the case of questions or faults.
See address on the reverse.
20
Troubleshooting
Cause
Air in the pump
Suction pipe blocked
Power supply interrupted
Thermal protection switch in
the motor has switched off
the pump as it was overheat-
ed.
Suction pipe blocked
Suction side is leaky
The quantity transported by
the pump depends on the
transport height and the con-
nected periphery
EN
Remedy
see chapter "Preparation" fig. A
and B and and chapter "Opera-
tions" fig. C
Pull out the mains plug and
clean the suction pipe
Check fuses and electrical con-
nections
Pull out the mains plug, let the
pump cool down, clean the suc-
tion area, prevent dry running
Pull out the mains plug and
clean the suction pipe
Check the entire suction side for
leaks
Keep max. flow height, see
technical data. If necessary, se-
lect a different hose diameter or
hose length.
– 7