SmartGyro Lobo Mode D'emploi page 30

Always use the original charger provided with the product and connect
it correctly to the device (through the charging port) and to a power
outlet. It is important that you always use the charger that comes with
your smartGyro, otherwise, it may cause the device to fail and not be
covered by the warranty. Once the product has been loaded, it will take
approximately two or three hours to complete the charge.
When the LED light changes to green, it means that the product is fully
charged. It is important that at that time, immediately disconnect the
adapter from the network to stop charging. The battery life will be
affected by the battery charging time, never exceed and will extend
the life of your battery.
Note that the approximate charging time is between4-5 hours. Do not
leave the product charging once the adapter light has turned green
or overcharge the battery for more than 3 hours.
Tips to keep in mind when loading
- Load preferably in locations away from flammable products.
- Monitor and control the charging period (which does not exceed the
recommended).
- Use only the original charger. - Do not leave it charging at night.
- If it has been exposed to high temperatures, wait and check that it is
not hot before charging again.
- For the charging procedure it is important that it be turned off and
that there is no accessory connected, since if it is not possible for any
of the sensors to be activated and the battery will overheat.
English
Lobo - User Manual
smartgyro.es smartgyro.es
28 1