Installing The Output Speed Ring - NuVinci Harmony 330 Manuel Technique D'utilisation

6.4 Installing the Output Speed Ring

Belt Compatible Harmony systems require an
output speed ring (A) that must be secured
over the CVP, flush with the CVP cover (B).
Six magnets in the output speed ring provide
bicycle speed for the Harmony system.

Chain-only Harmony systems do not
!
utilize the output speed ring, but
rather utilize a hub encoder. If you
are unsure of which system the bicycle came
installed with, see section 8.5.
1. Prior to installing the Harmony Hub
interface, assemble the output speed ring
over the right hand side of the CVP, and
secure with the included fastener (C).
•
The fastener may need to be unthreaded to
allow initial fitment.
•
Assemble with the larger diameter flange
outboard and the fastener inboard, flush
with the CVP cover as shown.
•
Locate the fastener portion between spoke
holes and spokes, as shown.
2. Torque the fastener to 1.0 Nm (9 in-lbs).
TECHNICAL OWNER MANUAL
A
B
C
HARMONY ASSEMBLY OF COMPONENTS
EN
14