Abus FUEM50000 Mode D'emploi page 22

Jumper B Multiple-vibration mode:
Jumper C Calibration:
Jumper D LED:
Sensitivity
Connect jumper C. Note: When the detector
battery is almost empty, the LED flashes
continuously for calibration mode. In this
case, replace the battery.
1. Turn the potentiometer anti-clockwise to
the stop. The detector is now at the low-
est sensitivity level.
When the multiple-vibration mode
is activated, the vibration detector
only sends an alarm after repeat-
ed vibrations.
Off
On
Use this jumper to set the detec-
tor to calibration mode or normal
operation.
Calibrate detector
Normal
Use this jumper to deactivate/
activate the LED on the detector.
Off
On
22