Hilti TE 30­A36 Mode D'emploi page 16

When changing the chuck, set the function selector switch to this
position: .
1. Remove the battery from the tool.
2. Grip the chuck as shown in the illustration and pull the three chuck release
rings upwards.
3. Fit the chuck onto the chuck mount.
4. Rotate the chuck until it engages in position.
5.1.8 Inserting the tool
1. Lightly grease the connection end of the accessory tool.
➥ Use only genuine Hilti grease. Using the wrong grease can result in
damage to the tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is
securely engaged.
➥ The product is ready for use.
5.1.9 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool gets hot during use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.2 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function
selection during operation.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2.1 Function selector switch
▶ Set the function selector switch to the desired working position.
➥ Do not operate the function selector switch while the motor is running.
Risk of damage!
5.2.2 Drilling without hammering
▶ Set the function selector switch to this symbol:
5.2.3 Drilling with hammering action (hammer drilling)
▶ Set the function selector switch to this symbol:
10 English
Printed: 30.04.2019 | Doc-Nr: PUB / 5351688 / 000 / 03
7
7
8
.
.
2173713
*2173713*