Hilti TE 30­A36 Mode D'emploi page 18

7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of
transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by
children or unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of
storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
8.1 The combihammer is in working order.
Trouble or fault
The battery runs
down more quickly
than usual.
The battery doesn't
engage with an audi-
ble click.
The control switch
can't be pressed, i.e.
the switch is locked.
The drive spindle
doesn't rotate.
12 English
Printed: 30.04.2019 | Doc-Nr: PUB / 5351688 / 000 / 03
Possible cause
Battery condition is not
optimal.
The retaining lugs on the
battery are dirty.
The forward / reverse
switch is in the middle
position.
The permissible operat-
ing temperature of the
combihammer's elec-
tronics has been ex-
ceeded.
Action to be taken
▶ Replace the battery.
▶ Clean the retaining
lugs and refit the
battery.
▶ Push the forward /
reverse switch to the
right or left.
▶ Allow the combiham-
mer to cool down.
2173713
*2173713*