Installation - Kuppersbusch IKE458-5-4T Notice D'utilisation

Installation

Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of
the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
Height adjustment
The height of the appliance is adjustable
from 820 to 870 mm to fine up with existing
kitchen units.
Before installing the appliance between
units, adjust the height of the feet and rear
wheels. The wheels are factory set for a
height of 820 mm. To align the appliance to
a height of 870 mm, raise it by adjusting the
feet with a spanner, then remove the
wheels and refit them in the lowest position.
Fitting the side panels
• Fit the brackets onto the panels in the po-
sitions shown in the diagram. The dimen-
sion of 260* mm is allowed for fitting a
100 mm plinth below the panel. For differ-
ent plinth sizes, increase the dimension
of 260* mm accordingly.
29