Daily Use - Samoa 366760 Guide D'instructions Et Pièces De Rechange

The user can choose between two different
operating modes:
The meter features a non-volatile memory for
storing the dispensing data, even in the event
of a complete power break for long periods.
The measurement electronics and the LCD
display are fitted in the top part of the meter
which remains isolated from the fluid-bath
The only operations that need to be done for
daily use are partial and/or resettable total
register resetting. The user should use only
the dispensing system of meter. Occasionally
the meter may need to be configured or
calibrated. To do so, please refer to the
relevant chapters.
NOTE: 6 digits are available for Totals,
plus two icons x 10 / x100. The
increment sequence is the following:
0.0 -> 99999.9 -> 999999 -> 100000 x
10 -> 999999 x 10 ->100000 x 100 ->
999999 x 100
4
836 828 R. 10/12
Samoa Industrial, S.A. · Box 103 Alto Pumarín · 33211 Gijón - Asturias Spain · Tel.: +34 985 381 488 · Fax.: + 34 985 384 163
Operating mode
Description
measurement chamber and sealed from the
outside by means of a cover.
1. Normal Mode: Mode with display of
Partial and Total dispensed quantities.
2. Flow Rate Mode: Mode with display of
Flow Rate, as well as Partial dispensed
quantity.

Daily use

Below are the two typical normal operation
displays. One display page shows the partial
and reset total registers. The other shows the
partial and general total. Switchover from
resettable total to general total display is
automatic and tied to phases and times that
are in factory set and cannot be changed.