Important - Bestway POWER STEEL B56622 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2
F
C
E
C
C
E
E
C
C
E
C
3
H
I
4
J
5
F
F
F
D
H
H
J
6
Connection Valve Assembly
For pool with connection valve
A
Assembly of the Frame pool can be completed without tools.

IMPORTANT:

Bestway Inflatables will not be responsible for damage caused to the pool due to
mishandling or failure to follow these instructions.
1. Lay out all parts and check that you have the correct quantities as listed in the components list. If you are
missing any parts do not assemble the pool and contact Bestway Customers Service.
2. Spread out the pool and make sure the pool is right side up; let it sit exposed to direct sunlight for 1 hour or
more so that the pool is more flexible during set up.
3. Place the pool near an adequate drainage system to deal with overflow water and ensure the pool's inlet A and
outlet B are correctly positioned to allow your filter pump to connect to a power source.
Note:
Do not use extension power cords to power your pump.
ATTENTION:
Do not drag the pool on the ground, this can damage the pool.
Filling Pool with Water
ATTENTION:
Do not leave pool unattended while filling with water
1. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could cause the pool to collapse. In times of
heavy rainfall you may need to empty some of the water to ensure the level is correct.
2. When filling the pool is completed, check that the water is not collecting on any side to ensure the pool is level.
IMPORTANT:
If pool is not level, drain water and re-level ground by digging out. Never attempt to
move the pool with water in it, serious personal injury or damage to the pool may result.
WARNING:
Your pool may contain a great deal of pressure.
If your pool has any bulge or uneven side then the pool is not level, the
sides may burst and the water may discharge suddenly causing serious
personal injury and/or damage to property.
3. Check pool for any leaks at valves or seams, check ground cloth for
any evident water loss. Do not add chemicals until this has been done.
NOTE:
In the event of a leak, patch your pool using the
underwater adhesive repair patch included provided. Refer to the FAQ's
for further information.
Proper Water Level
0%
30%
5
1in. - 2in.
2-5 cm
B
70%
90%

Publicité

Table des Matières
loading

Table des Matières