Important Safety Instructions; Proposition 65 Warning; Tools Needed; Parts Included - Thermador VCI 230 DS Guide D'installation

IMPORTANT SAFETY INSTRUCTIONS

WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A. Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including fire-
related construction.
B. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent backdrafting.
Follow the heating equipment manufacturer's
guideline and safety standards such as those pub-
lished by the National Fire Protection Association
(NFPA), and the American Society for Heating,
Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
C. When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
D. Ducted fans must always be vented to the out-
doors.
E. Always unplug or disconnect the appliance from
the power supply before servicing.
F. This unit is designed for indoor use only.
Use this unit only in the manner intended by the
manufacturer.
This unit is manufactured for indoor use only. Do not use
this unit outdoors.

Tools Needed

K Tape measure
K Philips screwdriver
K Duct tape
K Ductwork (configuration varies depending on location)
K Additional sheet metal screws (as necessary for
ductwork installation)
Read All Instructions Before Using the Appliance.
READ AND SAVE THESE INSTRUCTIONS.
Caution: For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and vapors.
To reduce risk of fire and to properly exhaust air, be sure
to duct air outside. Do not vent exhaust air into spaces
within walls, ceilings, attics, crawl spaces or garages.
TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCTWORK.
To reduce the risk of fire or electric shock, do not use
the fan with any solid-state speed control device.
This appliance has been found to be in compliance with
UL507 Standard for Electric Fans and CAN/CSA-22.2
No. 113 Canadian Standard for Fans and Ventilators. It
is the responsibility of the owner and the installer to
determine if additional requirements or standards apply
in specific installations.
To reduce the risk of fire and electrical shock, install this
rangehood only with blowers manufactured by BSH see
page 2.

Proposition 65 Warning:

This product may contain a chemical known to the
State of California, which can cause cancer or
reproductive harm. Therefore, the packaging of
your product may bear the following label as
required by California:

Parts Included

K Appliance assembly (1)
K Wood screws (4)
K Metrical screws M5x45 (4)
K Hardware for mounting brackets (2)
K Plugs UX6 (4)
PAGE 1
WARNING