Black & Decker FP5500BC Mode D'emploi page 10

• Rinse parts immediately after processing
for easier cleaning.
• Wipe base and feet with a damp cloth
and dry thoroughly. Stubborn spots can
be removed by rubbing with a damp cloth
and a mild, nonabrasive cleaner. Do not
immerse base in liquid.
• All removable parts can be washed by
hand in hot water with dish soap or in the
dishwasher, top rack only. Hand-washing of
plastic parts will help to maintain the food
processor's appearance.
• Do not use rough scouring pads or
cleansers on any plastic or metal parts to
clean.
• Do not allow blade or disc to soak in
water for long periods of time.
CL EA NI NG T IP S
• For quick clean up, combine 1 cup warm
water and a drop of liquid dish soap in the
food processor workbowl or blending jar.
• Cover and process on LOW for about 30
seconds.
• Discard liquid and rinse thoroughly.
TROU B LESHO OTIN G
PROBLEM
Food Processor
doesn't run
Food processor
not shredding or
slicing properly
If workbowl cover
won't close
If the problem is not due to one of the above items, see the "Warranty and Service" section of
this Use and Care Manual. Do not return the Food processor to the retailer. Retailers no not
provide service.
SOLUTION
• Make sure the workbowl and workbowl cover are properly
aligned and in place.
• Check to make sure the food processor is plugged in.
• If you have a circuit breaker box, be sure the circuit is closed.
• Unplug the food processor, and then plug it back into the
outlet.
• Make sure the disc is installed properly.
• Make sure ingredients are suitable for slicing or shredding.
• Make sure the disc or blade is installed correctly.
10
Important: Do not place the processor
parts in boiling liquids.
STO RAGE
Caution: Blades and discs are sharp.
Handle carefully.
To contain all of the food processor parts
within the workbowl, assemble in the
following order:
1. Place spindle on
motor unit.
2. Place workbowl
on motor unit and
lock.
3. Stack the
s-blade, dough
blade, and creamer
attachment on
spindle.
4. Place the drive
shaft sideways in
the workbowl.
5. Carefully fit slicing/shredding disc on
top of spindle.
6. Place cover on workbowl with the food
pusher in the feed chute.