First Use; Compatible Devices; Charging External Devices - SilverCrest SLS 13 A1 Mode D'emploi

SilverCrest SLS 13 A1
Make sure that the solar panel (A) is aligned optimally with the sun and receives sufficient sunlight.
Optimal efficiency is achieved when the sun's rays hit the solar cells (2) at an angle that is as
vertical as possible (figure a). The solar panel is less efficient if the sun's rays hit the solar cells (2)
at a flatter angle (figure b).

First use

Compatible devices

The solar panel (A) can be used to charge end devices which require a charging current of 2A at
most.
Before charging, check the suitability of your end device based on its technical data (operating
instructions).

Charging external devices

Connect the charging cable of your end device to one of the two USB ports (5) of the solar panel
(A) and to your device.
You can put your device into the pouch (3) while charging. This is especially useful if the solar
panel (A) is hung vertically because the opening of the pouch (3) is always facing upwards in this
case and your device cannot fall out. This is not guaranteed if the solar panel is hung horizontally
or is laid on a flat surface.
English - 19