Flo G5 Guide D'installation page 8

3
Hang the mounting plate securely
to a stable surface using a
minimum of 3 anchor screws.
4
Insert the conductors and secure the strain relief to the rear housing so that the
conductors are long enough to reach the terminals.
5
Secure the rear housing of the station to the mounting plate.
6
Screw the lower screw to secure the mounting.
7
Connect the two power wires (L1 and L2) and the ground wire (GND).
8
Tighten the connector nut. Ensure the wire is secure.
8
Anchoring screws
Mininum of 3
Maximum of 6
107 mm
4.22"
L1
L2
GND
178 mm / 7.62"
51 mm
2.25"
27 mm
1.06"
Nominal torque for conductors
L1-L2: 6 AWG = 16 lbs-in
8 AWG = 16 lbs-in
GND: 6 AWG = 45 lbs-in
8 AWG = 40 lbs-in
WARNING:
ALWAYS use a manual screwdriver; DO
NOT use an Impact Driver, risk voiding the
warranty if screws are damaged.
January 2019 | flo.com | Installation guide | FLO Home G5
152 mm
6.00"
406 mm
16.96"
152 mm
6.00"
42 mm
1.69"
Wall structure