Friedrich QuietMaster Programmable SS08 Manuel D'installation Et Mode D'emploi page 17

Figure F TYPICAL INSTALLATION
TRIM MOULDING
SCREW #12A x 2"
LONG (USE 3)
SILL PLATE GUIDE CHANNEL
INSIDE WALL SURFACE
STEP 6
Slide the cabinet into the hole far enough to allow the guide-
h c n a e n o l t f e h i s p l l a l
Figure F).
STEP 7 5
Drill three (3) " dia. pilot holes through holes in sill-plate
32
into framing and install three (3) #12A x 2" long screws (See
Figure F).
NOTE: ALTERNATE FASTENERS WHICH MAY BE USED FOR
SECURING THE SILL PLATE IN THE WALL AND THE SUPPORT
BRACKETS TO THE OUTSIDE WALL (NOT FURNISHED BUT
AVAILABLE AT LOCAL HARDWARE STORE).
EXPANSION ANCHOR BOLT
MOLLY OR TOGGLE BOLT
e t o t o c t n c a t t e h n i i s e d w l l a u s a f r
920-198-01
CAULK ALL SIDES WEATHER TIGHT
NOTE: SUPPORT BRACKETS MAY BE OMITTED
FROM THROUGH-THE-WALL INSTALLATIONS IF THE
CABINET IS SECURED AS FOLLOWS. DRILL 2 HOLES
IN EACH SIDE AND INSTALL 4 FASTENERS (2 EACH
SIDE). USE #12 x 2" SCREWS, TOGGLE BOLTS OR
EXPANSION ANCHOR BOLTS AS SHOWN IN STEP 7.
SUPPORT BRACKETS (AVAILABLE AS OPTION AL AC CES SORY)
SCREW #12 x 2" LONG, USE ONE EACH BRACKET.
DRILL 5 DIA. PILOT HOLES.
32
STEP 8
Drill two (2)
e c S ( e e shown (see Figure F) and install four (4) #12A x 2" screws (Item
# 4, page 9). Provided that Step 5 (hole construction) provides
a sturdy mount with solid vertical studs, no support brackets
are required. The installation must support the weight of the
unit plus an additional weight of 400 pounds on the rear of the
cabinet.
If support brackets are available, they can certainly be used for
through-the-wall installations as shown in Figure F.
If the reliability of the wall is in question, a window installation kit which
includes support brackets can be ordered (see Accessories).
STEP 9
If desired, trim around the cabinet on the room side with a suitable
frame moulding furnished by the installer (see Figure F).
STEP 10 Complete the installation by following steps 13 through 18 of SASH
W
STEP 11
Refer to the OPERATION SECTION for instructions.
" SLOPE DOWN
CABINET
5
" dia. pilot holes each cabinet side at the locations
32
N I D O W N I S A T L L T A O I N N I T S R U
NOTICE
Instructions for mounting sleeve with
slope must be observed to prevent entry
of water into room.
C T O I N S p , g a s e 3 1 1 - . 4
17