Timer Operation - BWT SR LIGHT SRF-1 Notice D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.

TIMER OPERATION

Instructions for use
PROGRAMMATION:
1.
Set the timer to the right time by synchronizing the wheel to the current time. Insert a screw driver
into the centre of the wheel to position the needles similar to the hands on a watch: the big needle
corresponds to the minutes, the small hand shows the hours.
2.
Next, rotate the ring until the time is aligned with the pointer. In the figure above, the setting corresponds
to 10 am.
3.
To define the switching intervals (the intervals during which filtration should run), push the relevant
segments toward the exterior of the timer dial as shown in the figure above. Each segment represents
15 minutes.
4.
Lastly, turn the rotary switch to the desired mode:
O
Stopped (out)
18/40
2021/01 - Indice de révision : G - Code : 32602
Automatic
(filter runs during the intervals
set on the timer)
I
Forced on (in)
CONSTRUCTION & RÉNOVATION

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sr light srf-100

Table des Matières