Connecting Multiple Sc-Rb5 Units; Bluetooth ® Connection; Auto Off Function; To Return To The Factory Preset State - Panasonic SC-RB5 Mode D'emploi

Connecting multiple SC-RB5 units

You can simultaneously output sound from multiple SC-RB5 units connected with audio cables
(not supplied). Connect the first SC-RB5 unit (AUDIO OUT terminal) to the second unit (AUX IN
terminal), and then connect the second unit (AUDIO OUT terminal) to the third unit (AUX IN
terminal).
• The sound effect will be controlled separately by each unit. Make the same sound settings on
the additional unit if necessary.
• Up to 3 units can be connected. Operation cannot be guaranteed if 4 or more units are
connected.
®
Bluetooth
connection
Audio cable (not supplied)

Auto Off function

This unit automatically turns off if there is no audio input and no operation is performed for
approximately 10 minutes.
Note
• This function will not operate when the AUX input is used while connected with the USB cable.
• This function may operate even when the music is being played back if the volume of the
connected device is low.
• This function may not operate depending on the connected device.

To return to the factory preset state

Perform the following when you want to delete pairing device information, etc.
1 Press [Í/I] to turn this unit on.
2 Touch and hold [
The pairing device information will be deleted by the reset, so it will be necessary to perform
pairing again. Delete the pairing information for this unit from the Bluetooth
the pairing operation again. (See "Bluetooth
10
10
1st
] and [VOL +] until [VOL –] indicator turns off.
2nd
Audio cable (not supplied)
®
pairing" 8)
3rd
®
device, then perform