Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
TOOLS NEEDED FOR ASSEMBLY
The stand needs to be assembled by the user.
Tools needed for assembly are (not supplied):
10 mm wrench, two 13 mm wrenches, two 17 mm
wrenches, two adjustable wrenches, 5 mm hex wrench,
a box cutter and a Phillips screwdriver.
ASSEMBLY INSTRUCTIONS
WARNING
For your own safety, never connect the miter saw
plug to any power source outlet until all assembly and
adjustment steps are completed, and you have read
and understood the safety and operating instructions
for both this stand and your miter saw.
Use the box cutter to carefully open the carton and cut
the cable ties. Place the main stand assembly on a
large, flat surface with the top facing down. Open the
stand legs by releasing the green 'foot' pedal.
INSTALLING THE BUMPERS (FIG. A)
1. Hardware Bag "O" - Attach one bumper (1) to the
stand with a screw (2) and a nut (3) and tighten
using a Phillips screwdriver and a 10 mm wrench.
Do not overtighten.
2. Repeat the same installation procedure for the
other bumper (4).
Fig. A
2
INSTALLING THE TWO LINK BARS (FIG. B)
NOTE: One end of the link bar (4) is attached to the
stand assembly. You need to attach the other end to
the stand.
1. Hardware Bag "N" - Insert the bolt (1) and curved
washer (6) through the hole on the stand tube (2),
into the flat washer (3) and the link bar (4).
ASSEMBLY
3
1
4
NOTE: The flat washer (3) should be placed
between the tube (2) and the link bar (4).
2. Tighten the bolt (1) with the lock nut (5) using two
13 mm wrenches or two adjustable wrenches. Do
not overtighten.
NOTE: Make sure the curved washers are flush
against the stand leg before tightening.
3. Repeat the same installation procedure for the
other link bar.
Fig. B
2
5
INSTALLING THE RIGHT STAND LEG ASSEMBLY
(FIG. C)
1. Hardware Bag "M"- Insert the right stand leg (1)
into the stand (2).
NOTE: Align the four holes of the right stand leg
with the holes on the stand.
2. Insert the bolt (3) through a curved washer (4) and
into one of the holes (5) in the stand. Place another
curved washer (4) and then a lock nut (6). Tighten
using two 13 mm or adjustable wrenches.
3. Repeat for the three other holes. There are two
mounting holes on each side for securing the right
stand leg assembly to the stand.
NOTE: Make sure the curved washers are flush with
against the stand leg before tightening.
Fig. C
6
2
– 8 –
3
6
1
4
3
4
5
4
1
Publicité
Table des Matières
