Metabo HPT UU 240R Instructions De Sécurité Et Mode D'emploi page 10

English
INSTALLING THE EXTENSION SUPPORT ASSEMBLY
(FIG. G, H)
NOTE: The longer side of the horizontal tube (1) should
point toward the user (front) as shown in Fig. G.
1. Hardware Bag "K"- Attach the left fence (2) to the
left extension support (3) and secure by the lock
knob (4) with the shorter length threads and a flat
washer (5). (Fig. G)
NOTE: There is a "L" mark on the inner side of the
left fence and a "R" mark on the inner side of the
right fence, not shown in the figure.
2. Repeat the above steps for installing the right fence
to the right extension support.
Fig. G
5
4
1
left extension support
3. Insert the right extension support assembly (6) into
the right extension support arm (7) and secure with
the height adjustable knob (8) with the longer length
threads. (Fig. H)
4. Repeat the above steps for installing the left
extension support assembly.
Fig. H
1
Long
side
3
2
1
right extension support
6
7
8
INSTALLING THE SAW MOUNTING BRACKETS
(FIG. I)
NOTE: The cam latches of the saw mounting brackets
should point toward the user (front) as shown in Fig. I.
1. Press the locking button (1) and lift up on the cam
latch (2).
2. Place the rear holding clamp (3) on the rear rail of
the stand, and then lower the front end of the saw
mounting bracket over the front rail of the stand.
3. Slide the saw mounting bracket to the desired
position, and then push down the cam latch (2)
to lock.
4. Repeat the above steps for the other saw mounting
bracket.
NOTE: If either mounting bracket does not slide
smoothly on the stand bed when unlocked, see page 13
on "ADJUSTING THE SAW MOUNTING BRACKETS".
Fig. I
3
POWER CORD HOOKS (FIG. J)
NOTE: These power cord hooks are pre-assembled at
the factory.
Storage for the power cord is located on the ends of the
saw mounting brackets (1). Wrap the power cord onto
the hooks (2) when the saw is not in use. This can help
prevent damage to the power cord.
Fig. J
– 10 –
1
1
2
2