Carton Contents - Metabo HPT UU 240R Instructions De Sécurité Et Mode D'emploi

falling down from the stand rails. Remove the miter saw with the mounting brackets carefully by two or more people.
● When transporting the stand in a vehicle, securely tie it down to prevent movement and possible damage.
● To reduce the risk of injury, periodically check that all fasteners are attached and adjusted according to the assembly
instructions included in this manual.
● If any part of the stand is not operating properly, the stand must be serviced before use. When servicing the stand,
use only identical metabo HPT replacement parts. Repairs should be conducted only by a metabo HPT authorized
service center.
SAVE THESE INSTRUCTIONS AND MAKE THEM AVAILABLE TO OTHER USERS AND
OWNERS OF THIS STAND.
UNPACKING YOUR STAND
This product requires assembly.
1. Remove the stand and all parts from the carton.
2. Place the stand on the ground.
3. Separate all parts from the packing material. Check each one with the list below and the illustration on page 6 to
make certain all items are accounted before discarding any packing material.
If any part is missing or damaged, do not attempt to assemble the stand until the missing or damaged part is correctly
replaced.
TABLE OF LOOSE PARTS
ITEM
A Stand
B Right stand leg assembly
C Stand handle tube
D Stand leg tube with foot pad
E Miter saw mounting bracket
F Auxiliary mounting bracket
G Stand leg tube with adjustable foot pad
H Left extension support
I Right extension support
J Fence (left and right)
K Extension support assembly lock knob hardware bag
L Stand handle assembly hardware bag
M Stand leg assembly hardware bag
N Link bar assembly hardware bag
O Bumper assembly hardware bag
P Anchor plates
Q Auxiliary mounting brackets assembly hardware bag
R Wheel mounting assembly hardware bag
S Wheel
NOTE: In case of missing or damaged parts, please contact metabo HPT at (800) 546-1666 for assistance.

CARTON CONTENTS

WARNING
DESCRIPTION
– 5 –
English
QUANTITY
1
1
2
1
2
2
1
1
1
2
1
1
1
1
1
1
1
1
2