Metabo HPT UU 240R Instructions De Sécurité Et Mode D'emploi page 11

MOUNTING THE SAW TO THE STAND
WARNING
● Do not mount the miter saw to the stand without
first ensuring the stand is extended fully and locked
securely. To set up the stand, follow the instruction
in section "SETTING UP THE STAND" on page 15.
Failure to do so may result in possible injury and
damage to the stand and the miter saw.
● Always use the saw mounting brackets and auxiliary
mounting brackets together when mounting the miter
saw to the stand.
● Before operating the mounted miter saw, read
carefully the instruction manual for the miter saw.
USING THE AUXILIARY MOUNTING BRACKETS
(FIG. K, L, M, N)
1. Hardware Bag "Q"- Insert two square nuts (1)
into the slot on each end of both auxiliary mounting
brackets (2) and slide them to the middle of the
auxiliary mounting brackets (2). (Fig. K)
Fig. K
2
1
2. Insert two large washers (3) into the auxiliary
mounting bracket (2) and align with the holes at the
end of the auxiliary mounting bracket (2). (Fig. L)
3. To mount the auxiliary mounting bracket (2) onto
the saw mounting brackets (4), insert the screw (5)
through the inserted washer (3) and the square nut (1)
below the saw mounting bracket (4) for fixing each end
of the auxiliary mounting bracket (2) by using 5 mm
hex wrench.
4. Repeat the above steps of 2 & 3 for assembling the
other auxiliary mounting bracket.
NOTE: Do not tighten the four screws (5) securely at
this time.
Fig. L
4
5. Make sure the cam latches (6) of the saw mounting
brackets (4) are in the unlocked position. (Fig. M)
6. Lower the rear and front ends of the mounting
brackets assembly onto the rear and front rails of the
stand. The front holding clamps of the saw mounting
brackets (4) must seat fully on the front rail. Make
sure that the saw mounting brackets are positioned
at right angle to the front and rear rail.
7. Lock the mounting brackets assembly in position by
pressing down on the two cam latches (6).
● Ensure that the saw mounting brackets are clamped
securely on the stand before mounting the miter saw.
● Stay alert. The stand and miter saw may fall down
during the procedure and cause serious injury.
● To reduce the risk of injury, ensure all bolts and nuts
are properly tightened and all mechanisms properly
function after completing assembling and before
each use.
Fig. M
mounting brackets
assembly
– 11 –
5
3
2
1
WARNING
English
4
6