Annovi Reverberi BLUE CLEAN 1435 Mode D'emploi page 5

10 English
3.1.17 W
arning
EN
components, the high pressure jet is potentially dangerous. Do not use the
rotating nozzle kit, and always keep the jet at a distance of at least 30 cm during
cleaning.
3.1.18 W
arning
specifically intended for the model in question is prohibited. All modifications to
the appliance are prohibited; any modifications shall render the Declaration of
Conformity null and void and relieve the manufacturer of all liability under civil
and criminal law.
3.1.19 W
arning
3.1.20 W
arning
3.2 SAFETY "MUSTS"
3.2.1 W
arning
3.2.2
W
arning
clothing (PPE) and equipment needed to ensure the operator' s safety.
3.2.3 W
arning
Remove the spark plug connector prior to performing any work on the device.
3.2.4 W
arning
3.2.5 W
arning
Under IEC 60335-2-79, the appliance may only be connected to the mains
drinking water supply if the supply hose is fitted with a backflow preventer valve
with drain facility corresponding to EN 12729 type BA. The backflow preventer
can be ordered from the manufacturer.
3.2.6 W
arning
be non-potable.
3.2.7 W
arning
out by qualified staff.
3.2.8 W
arning
appliance.
3.2.9 W
arning
tightened and that there are no broken or worn parts.
3.2.10 W
arning
the high pressure hose / electric cable.
93735_ARBC_Termik_1435 1440 1444 1445 1450.indb 10
. When directed towards tyres, tyre valves or other pressurised
. The use of non-original accessories and any other spare parts not
. Do not bend over the exhaust or touch it. (Risk of burns).
. Do not touch hot mufflers, cylinders or radiator ribs. (Risk of burns).
. All electrical conductors MUST BE PROTECTED against the water jet.
. High pressure may cause parts to rebound: wear all the protective
. Risk of injury if the machine is left running in an unattended state.
. Before pressing the trigger, GRIP the gun firmly to counteract the recoil.
. COMPLY WITH the local water supply authority regulations.
. Water that has passed through backflow preventers is considered to
. Maintenance and/or repair of electrical components MUST be carried
. DISCHARGE residual pressure before disconnecting the hose from the
. CHECK before each use and at regular intervals that the screws are fully
. ONLY USE detergents which will not corrode the coating materials of
17/6/14 下午4:16