Replacing An Existing Drain Pump - AGA marvel 41013943 Instructions D'installation, D'utilisation Et D'entretien

Replacing an existing drain pump:

1) Remove the ice machine from the installation and unplug
the power cord from the electrical outlet.
2) Remove the 2 screws from the vent tube clamps and all
of the screws around the perimeter of the access cover with
the ⁄ " nutdriver. remove the access cover from the ice
5
16
machine. (See Figure 9).
3) Remove the 4 hose clamps from the drain pump and
remove the 3 tubes from the drain pump. See Figure 10.
4) Remove the leveling leg in the left back corner. See
Figure 10.
NOTE
Inspect the following parts for damage, 18" (45.7 cm)
vent tube, 20 feet (6.1 meters) discharge tube, and hose
clamps. Replacement parts, if required, are provided in the
drain pump kit.
Remove this rear leveling leg
DRAIN PUMP INSTALLATION
around perimeter
Remove these 4 hose
clamps, then remove the
3 tubes from the drain
pump
Drain pump ground
Figure 10
wire connection
8
Vent tube
Remove (2)
screws from
vent tube
clamps
Remove screws
of access cover
Figure 9
Dis-
charge
line
Access
cover
Electrical
power cord