AGA marvel 41013943 Instructions D'installation, D'utilisation Et D'entretien page 4

4) Remove the power cord connector from the main elec-
tronic board. Depress the latch on the inside of the connec-
tor and pull down to disengage the connector. See Figure
4. Place the end of the power cord with the connector
toward the back of the ice machine.
DRAIN PUMP INSTALLATION
5) Take the 18" wire harness from the drain pump kit and
connect it to the main board where the power cord connec-
tor was removed. Remove the hex nut on the front carriage
bolt with a
the ground wire under the hex nut. Tighten the hex nut.
Slide the plug end of the 18" harness through the unit so it
can be accessed from the back of the ice machine.
Latch tab on
inside of
connector
Figure 4
4
⁄ " open end wrench (see Figure 5) and attach
3
8
Power cord
connector
Hex nut
Ground wire
Figure 5