Table des Matières
Publicité
Filling water
Before you fill the drinking water into the
water tank, ensure that the water tank is
steady and in a correct position.
Caution!
Fill with water up to 3L (which is
suggested), and not above the level.
Otherwise, it may overflow when the lid is
close.
We recommend that you fill the water by
the following ways.
1. Remove the small lid and fill water from
the inlet of the large lid.
2. Remove the cover of the tank, and then
fill water inside directly.
Small lid
Large lid
Warning!
Don't touch other parts of the appliance
when filling water, it may cause the
water leakage.
Dispensing water
1. Make sure the cover of the water tank
is fitted on.
2. Close the fridge door and check the
dispenser.
Lock
Before you dispense the water, make
sure the lock device is on "UNLOCK"
situation.
Warning!
The lock is defined as "child lock".
Don't push the dispenser lever forward
strongly, when the dispenser is on
"LOCK" situation, it may damage the
mechanism.
Receiving Water
You should use the correct cups to
r e c e i v e w a t e r
dispenser.
Warning!
Head
Don't push the dispenser lever forward
without cup, it may cause the water leak
from the dispenser.
1. Put the water tank out of the door
carefully, and then wash the tank, lid, and
head lightly in water.
2. After you have successfully cleaned
the appliance, you should dry it by
natural drying or using the dryer.
3.If you have used the water dispenser
for many times, the water in the receiving
tank may drop on the floor, which may
make your floor wet, and you should
clean the tank with dry towel regularly
before overflow.
u n d e r n e a t h
Dispenser lever
Suggested position
Cleaning
Receiving tank
14
t h e w a t e r
Publicité
Table des Matières
Dépannage
