Function Information Of Display Interface - Hkoenig SWR32 Manuel D'utilisation

Function information of display interface

Make sure full charged 5/6 hours (the battery should be charged and discharged for about 2 or 3 times before reaching
the best performance). Turn on the power switch, the buzzer will ring once and the display will show as follows :
1. displays the current date per week automatically based on the date.
2. displays in case of malfunction, "88:88" displays the failure code from E001 to 034.
3. displays the battery, three grids mean full power, or decreased power with less grids.
4. means the cleaner is in charging, the battery is not enough if the icon is flickering, or full if stops
flickering..
5. displays the timing cleaning time, surrent time per day and malfunction code..
6. means running speed ; faste speed on speed 1, or slow on speed 2.
7. displays the UV lamp is on when the cleaner is working, when open the UV lamp, it can sterilize, or off
when not working.
8. displays the cleaner is cleaning in the spot cleaning mode.
9. displays the cleaner is cleaning in the auto cleaning mode.
The following displays functions will only be selected and set in the remote control :
1. means selecting cleaning day or some days or everyday of one week.
2. displays the time and timing cleaning setting.
3. means adjusting the speed of the wheel.
4. displays the current date per week.
Touch keys
1. Auto cleaning key
2. Spot cleaning key
3. UV lamp key
:
The keys of main body are of electronic touch type, you only need to touch them lightly with your finger while using it.
Besides, you should clean the keys and the space between them to remove water or oil stains, or may cause the touch failure.
a
Clear up gadgets or obstacles in the room before cleaning, and then press Automatic cleaning
key, it will clean by spiral, linear, zigzag, follow the wall modes automatically.
b
You can choose fast or slow running when cleaning.
c
The cleaner will stop running in case of low battery, then it will ring ten times and search the
docking station for charging automatically.
d
The cleaner will stop cleaning if you press any keys during cleaning.
a
Press spot cleaning key, it will enter the area about 1m² and clean by the spiral mode.
b
Choose the fast cleaning time of about 2 minutes and low cleaning time of about 4 minutes,
and it will stop automatically after the cleaning.
C The cleaner will stop cleaning if you press any keys during cleaning.
This cleaner is supplied of a UV lamp which can disinfect the floor and it is especially suitable
for people suffering allergy or for home with pets.
a
Turn on the power of the main body, the display will light.
b
Press the UV key, the icon
working, or off if the cleaner stops working.
c
If the UV lamp is unused, press the key to turn off, the icon will be off.
d
The on/off mode of UV lamp will be memorized automatically.
Function description
will be display, UV lamp will be on if the cleaner is