Preparation - Velleman CAMSET24 Notice D'emploi

5. Overview
Refer to the illustrations on page 2 of this manual.
A camera
1 white LEDs
2 lens
3 spring
4 gold plated connector
B monitor
1 video input channel button
2 menu button
3 down button
4 up button
5 select button
6 LED on/off button
7 power button + LED
8 LCD
C reel + cable
1 cable connector
2 handle
3 camera connector
J
remote control
1 power on/off
2 start record
3 select/play/pause
4 up
5 down
case LED
SYSTEM
RECORDING
USB
ERROR
IR

6. Preparation

Important: only switch on the power after all connections are made. Connecting devices to a live
system will surely cause damage.
•
Open the case [D]by pushing on the bottom of the locks until the levers jump out. Then pull up
the levers and lift the top of the case. To close, close the top and push the levers all the way
down.
•
Screw the camera connector [A4] on the cable [C3].
•
Connect the cable [C1] to the connection cable [I] and plug the other end of the connection
cable [I] into the case connector [D3]. All connectors are slotted and fit only one way. Do not
force.
•
There are two ways to power the system:
via the 12VDC adaptor [G]
o
Insert the 12VDC power plug into the 12VDC power input [D1] of the case.
using the battery pack [E]
o
05/05/2010
CAMSET24
ON
system power on
images are currently being recorded
USB device connected
problem detected with USB device
remote control in use
D case
1 12VDC input
2 video output
3 cable connector
4 USB port
5 status indication LEDs
6 sunscreen
E battery pack
1 12VDC output
2 status indication LEDs
3 power on/off switch
4 AC input connector
5 fuse
F AC power cord
G 12VDC adaptor
H protective cap for camera
I connection cable
J
6 left
7 right
8 system setup
9 confirm/stop/return
10 fast reverse
11 fast forward
no power
no recording
no USB device recognized
no problems detected
no remote control reception
4
SETUP
STOP
OFF
© 2008 Velleman Components nv