General Guidelines; Preparation - Velleman HR1F002 Mode D'emploi

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Keep this device away from dust and extreme temperatures.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
•
Familiarise yourself with the functions of the device before actually using it.
•
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
•
Warranty is limited to the device itself; installation and use of the included software is the sole risk of
the user.
•
Always allow the device to reach room temperature before switching it on.
•
Do not use the device if condensation forms inside the lens. Let the water evaporate before using
again.
•
The camera and gooseneck are waterproof and can be submerged in pH-neutral liquid (not acid or
alkaline). Never submerge the handle as this will cause irreversible damage. Keep the handle away
from rain, moisture, splashing and dripping liquids.
•
Avoid strong mechanical strains or vibrations. The bending radius of the gooseneck must be at least
6 cm.
•
Clean the CAMCOLI4 after each use.
•
Do not use when visible damage to the device is noticed.
4. Features
•
ideal for checking hard-to-reach areas, e.g. behind walls, suspended ceilings, etc.
•
4 built-in white LEDs
•
adjustable LED intensity.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 LED brightness control
2 snapshot button
3 handle
6.

Preparation

Installing the Driver on Windows XP or Earlier
On Windows XP® operating system (or earlier), proceed as follows:
1. Connect the camera to a free USB 2.0 port on your pc.
Note: Make sure to use USB 2.0 or higher. Correct operation is not guaranteed with USB 1.1.
2. Windows automatically recognises the device and installs the driver. Depending on the settings,
Windows may (not) display the message "Your new hardware is installed and ready for use".
Your camera is now ready for use.
Installing the Driver on Windows Vista / 7
For Windows Vista / 7, proceed as follows:
1. Connect the camera to a free USB 2.0 port on your pc.
Note: Make sure to use USB 2.0 or higher. Correct operation is not guaranteed with USB 1.1.
2. Insert the included CD-ROM in your pc.
V. 01 – 06/09/2012
CAMCOLI4
4 gooseneck (± 60 cm)
5 camera head with LEDs
6 accessory tools: hook, magnet
3 ©Velleman nv