Closing The Door; Technical Data; Installation; Electrical Connection - Atag KF8178CDL/A01 Notice D'utilisation

22
Problem
There is too much frost.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on
the door, you must ensure that it is
made unusable to prevent young
children being trapped inside.
Important! The appliance shall have the
plug accessible after installation.
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
Possible cause
Food is not wrapped correctly.
The temperature regulator is not
set correctly.
Height
Width
Depth
Wrap the food correctly.
Set a higher temperature.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1780 mm
560 mm
550 mm
21 h
230-240 V
50 Hz
Climate Ambient temperature
class
T +16°C to + 43°C

Electrical connection

Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
Solution