Closing The Door - Atag KD72102CN Notice D'utilisation

Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

Closing the door

1. Clean the door gaskets.
Possible cause
The "FastFreeze" is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
This is normal, no error
has occurred.
The "FastFreeze function"
is switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The food products' tem‐
perature is too high.
The door has been
opened often.
The "FastFreeze function"
is switched on.
There is no cold air circu‐
lation in the appliance.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Refer to "FastFreeze function".
Refer to "Closing the door".
The compressor starts after a
period of time.
Switch off "FastFreeze func‐
tion" manually, or wait until the
resets automatically to set the
temperature. Refer to "Fast‐
Freeze function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Open the door only if necessa‐
ry.
Refer to "FastFreeze function".
Make sure that there is cold
air circulation in the appliance.
25