15. Alarm function for temperature/humidity
The basis station offers the option of emitting an alarm signal when a temperature
threshold is exceeded and/or undercut (can be set separately for indoor temperature/
indoor humidity and outdoor temperature/outdoor humidity of each outdoors sensor
respectively).
a) Set values for automatic function, switch alarm function on/off
If no button is pushed for a few seconds, the basis station will leave setting
mode automatically.
• Push the respective button "CHANNEL/+" (17) briefly repeatedly until the arrow sym-
bol (5) appears under the desired channel (outdoor sensor or the indoor sensor).
• Press and hold the "ALARM/ADJUST" (16) button for 3 seconds.
• The display shows "HI AL" to the right of the temperature and the currently set value
for the upper temperature threshold will flash.
• Change the flashing value with the button "MIN/MAX/-" (15) or "CHANNEL/+." (17).
Keep the respective button pressed for quick adjustment.
• If the alarm is to be switched on or off, keep the button "ALARM/
ADJUST" (16) pushed for 3 seconds. When the alarm is switched on, the symbol
"
" appears.
• If you briefly push the button "ALARM/ADJUST" (16), "LO AL" appears to the right of
the temperature in the display and the currently set value for the lower temperature
limit will flash.
• Change the flashing value with the button "MIN/MAX/-" (15) or "CHANNEL/+." (17).
Keep the respective button pressed for quick adjustment.
• If the alarm is to be switched on or off, keep the button "ALARM/
ADJUST" (16) pushed for 3 seconds. When the alarm is switched on, the symbol
"
" appears.
• If you briefly push the button "ALARM/ADJUST" (16), "HI AL" appears to the right of
the humidity in the display and the currently set value for the upper humidity thresh-
old will flash.
• Change the flashing value with the button "MIN/MAX/-" (15) or "CHANNEL/+." (17).
Keep the respective button pressed for quick adjustment.
42