Inserting Batteries Into The Basis Station - Renkforce 1380336 Mode D'emploi

c) Inserting batteries into the basis station
• Open the battery compartment (19) on the back of the basis station.
• Insert 4 type AAA/Micro batteries into the basis station in the correct polarity (ob-
serve plus/+ and minus/-). Close the battery compartment again.
• Right after inserting the batteries, the basis station will briefly display all display seg-
ments and a signal sound is audible. If only chaotic characters appear in the display,
take out the batteries for a few seconds and insert them again.
• Then the basis station will start scanning for the radio signal of the outdoor sensors;
the reception signal (7) will appear to the right of the channel number 1, 2 and 3. This
sensor search can take several minutes.
Do not push any buttons, do not move the basis station and the outdoor sen-
sors.
If the basis station does not display any measured data from the outdoor sensors
after several minutes, take the batteries from the basis station and outdoor sensor
and proceed again as described above.
Always check the settings of the transmission channels of the outdoor sen-
sors. Each outdoor sensor must be registered on a different channel.
We recommend setting the 3 enclosed outdoor sensors to transmission chan-
nels 1, 2 and 3 (and not to transmission channels 4 - 8).
You can also start a manual search for the available outdoor sensors. For this,
observe the chapter "Starting a Manual Search for the Outdoor Sensors".
36