Switching Between °C/°F Temperature Units; Temperature Trend; Comfort Indicator - Renkforce 1380336 Mode D'emploi

11. Switching between °C/°F temperature units
• While the basis station shows the current measured values, push the button "MIN/
MAX" (15) for about 3 seconds to switch between the temperature unit °C (degrees
Celsius and °F (degrees Fahrenheit).
• If the temperature unit in the display of the outdoor sensor is to be switched, open the
battery compartment of the outdoor sensor. Take out the batteries and wait until the
display goes out.
Set the DIP switch 4 according to the table in chapter "Commissioning".
Replace the batteries and close the battery compartment. If the outdoor sensor is
no longer found (only dashes appear in the corresponding display area of the basis
station), you need to perform a sensor search as described above.

12. Temperature trend

To the right of the temperature, arrow symbols for the temperature trend are displayed
(rising, even or falling).

13. Comfort indicator

Symbols for the comfort indicator appear between the temperature and humidity dis-
plays. It is calculated based on the humidity.
" " Humidity <45% (dry)
" " Humidity >65% (moist)
" " Humidity 45%....65% (optimal)
40