Have Measuring Data Displayed Manually; Changing The Measuring Data Automatically - Renkforce 1380336 Mode D'emploi

10. Display of the measuring data at more than
3 outdoor sensors
If you have registered more than 3 outdoor sensors to the basis station, you can either
display the measured data manually or activate an automatic display.
a) Have measuring data displayed manually
• Push the button "CHANNEL/+" (17) briefly repeatedly until the arrow symbol (5) is
shown under the indoor temperature.
• If you push the "CHANNEL/+" button (17) again briefly (several times if necessary),
the display "IN" will disappear and the channel number (4....8) and the associated
measured data will appear below, depending on how many outdoor sensors are reg-
istered.
This is, of course, only possible if further outdoor sensors are actually reg-
istered with the transmission channels 4 - 8. Otherwise, the display "IN" re-
mains.
b) Changing the measuring data automatically
This is only possible if outdoor sensors with the transmission channels 4 - 8
are registered.
• Push the button "CHANNEL/+" (17) briefly repeatedly until the arrow symbol (5) is
shown under the indoor temperature.
• If you now push the "CHANNEL/+" button (17) again (several times if necessary), the
symbol " " will be shown in the lower left at some point.
Then the measured values for indoor temperature/humidity and the measured
values of the outdoor sensors 4 - 8 (if logged on) will appear in the lower dis-
play line.
39