Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A
B
C
BAttErY cHArGEr controLS
controLS And indicAtorS
[A] Digital Display – Gives a digital indication of voltage, %
of charge, or time, depending on the Display Mode chosen.
[B] Up/Down Arrows (switches) – Used to change any
variable settings on the display.
[C] Power ON/OFF (switch) – Controls the charging output
of the unit.
[D] Display Mode (switch) – Switches the display between
VOLTS – BATTERY % - ALT % - or TIME.
[E] Battery Voltage (switch) – Select from 6V, 12V, 24V, or to
do Flash Reprogramming.
[F] Battery Type (switch) – Select from Standard, AGM
or Gel type of battery being charged. Also used to enter
manual mode.
[G] Charge Rate (switch) - Select from Trickle Charge (max
4 amp rate), Fast Charge (max 15 amp rate), Rapid Charge
(max 60 amp rate), and Engine Start (max 300 amp rate).
rEProGrAMMinG tHE dEFAuLtS
Charger Start-up Mode defaults. If you are satisfied with the
default settings, skip to Automatic Charging section.
The first time you power up the charger, the default settings
are set to:
DISPLAY MODE – VOLTS
BATTERY VOLTAGE – 12V
BATTERY TYPE – STANDARD
CHARGE RATE – RAPID
to change the power up default settings:
1.
Change to the desired DISPLAY MODE, BATTERY
VOLTAGE, BATTERY TYPE, and CHARGE RATE.
2.
Press and hold both Up and Down Arrow switches at the
same time until the LED's stop flashing.
3.
The next time you power up the unit, these settings will
be saved and become the startup default settings.
EEBc500-int-Z
D
G
E
F
AutoMAtic cHArGinG
1.
Set Battery VOLTAGE to 6V, 12V, or 24V.
2.
Set BATTERY TYPE to STANDARD, AGM, or GEL CELL.
If unsure, consult the label on the battery or the battery
manufacturer.
3.
Set CHARGE RATE to TRICKLE, FAST, or RAPID –
smaller batteries (lawn tractor, motorcycle, etc.) should
not be set on RAPID.
4.
Charging will start when the ON/OFF button is pressed
and finish automatically.
5.
CHARGED (green) LED will light when finished and
charger will maintain battery.
notE: For a battery with a starting voltage under one volt,
use manual mode first to pre-charge the battery for five
minutes, to get additional voltage into the battery for the
charger to analyze.
MAnuAL cHArGinG
1.
Set Battery VOLTAGE to 6V, 12V, or 24V.
2.
Set BATTERY TYPE to MANUAL.
3.
Set CHARGE RATE to TRICKLE, FAST, or RAPID –
smaller batteries (lawn tractor, motorcycle, etc.) should
not be set to RAPID.
4.
Use the "UP" and "DOWN" buttons to adjust the charge
time (shown on digital display).
8
•
•
Publicité
Table des Matières
